|
Direct
Drive Stirring System for Standard Cells: Direct
drive stirring systems are recommended when modification of the
spectrophotometer cell compartment is not practical. Direct stirrers are
supplied with 6 disposable PTFE shafts. Direct drive systems are
illustrated below. The tapered adapter may also be used with
semi-micro and micro stopper tops. |
|
|
|
|
|
CTR-11 Electronic
Controller
|
|
 |
|
SYS-D1
Direct Drive Single Channel System: For Standard Cells
- CTR-11 Single
Electronic Controller
- D1-SET Motor kit with
3 standard cell adapters
- A-9032 120 Volt
Adapter
|
|

|
|
 |
|
SYS-M1
Direct Drive Single Channel System: For Micro Cells
- CTR-11 Single
Electronic Controller
- M1-SET Motor kit with
3 micro cell adapters
- A-9032 120 Volt
Adapter
|
|
|
|
|
|
CTR-21
Electronic Controller
|
|
  |
|
SYS-2D
Direct Drive Dual Channel System: For Standard Cells
- CTR-21 Dual Channel
Electronic Controller
- D1-SET Motor kit with
3 standard cell adapters (2 sets)
- A-9032 120 Volt
Adapter
|
|

|
|
  |
|
SYS-2M
Direct Drive Dual Channel System: For Micro Cells
- CTR-21 Dual Channel
Electronic Controller
- M1-SET Motor kit with
3 micro cell adapters (2 sets)
- A-9032 120 Volt
Adapter
|
|
|
|
|
|
D1-SET |
|
D1-SET Illustrated
above, the D1-SET was designed for standard cells such as 10x10 mm
cells, stopper top, and semi-micro cells. This set consists of one
motor, three cell adapters, and 6 disposable PTFE shafts. |
|
|
|
|
|
M1-SET |
|
M1-SET
Illustrated above, the M1-SET was designed for micro cells such as micro
long, micro short, and semi-micro cells. This set consists of one motor,
three cell adapters, and 6 disposable PTFE shafts. |
|
|
|
|
|
 |
|
- L = 65 mm (overall
length, 70 mm)
- D = 12 mm (motor
diameter)
- A = 1.25
mm (shaft diameter)
-
- Specifications
- Input Voltage: 9
- 12 VDC, 100mA
- Output Voltage: 0
- 2.7 VDC
- Speed Range: 200
- 2800 RPM
|
|
|
|
|